FAQ

FAQs are organized by topic and located at the end of each relevant documentation page. This makes it easier to find answers related to specific components or procedures.

Finding FAQs

To find answers to your questions:

1. Use the search bar (top of the page) to search for keywords related to your question
2. Check the relevant topic page - Each major section has its own FAQ section at the bottom:
3. Shuttle FAQ - Magnets, mating, preload, OctoTAP boards
4. Docks FAQ - Dock mounting, tool positioning, crossbar installation
5. Probes FAQ - TAP, sexball, Nudge, calibration
6. Endstops FAQ - Sensorless homing, Z offset
7. Top Hat FAQ - Enclosure requirements, umbilical exits
8. Cable Management FAQ - Timer Too Close errors, wiring issues
9. Toolheads FAQ - Toolhead selection, mixing toolheads, ooze prevention
10. Software FAQ - General software questions, tool changes, macros
11. Installation FAQ - Installation errors, Kalico compatibility
12. Configuration FAQ - Tool numbering, tool heating, macros
13. Slicers FAQ - PrusaSlicer, OrcaSlicer, pressure advance, ooze prevention
14. Tool Calibration FAQ - Offsets, probe calibration, pressure advance
15. Dock Calibration FAQ - Dock speed, Z velocity, tool pickup recovery
16. Dock Tuner FAQ - Dock Tuner tool usage and troubleshooting

17. Additional Tuning FAQ - Post-first-print fine-tuning tips

18. Still stuck? Join the community on Discord:

Build Guide

Need a narrated walkthrough? Start with the Building Overview and follow the community stream by ZombieHedgehog:

Episode	Link
1	https://youtu.be/YK2Zk2K584Y
2	https://youtu.be/yOGEAGLlvZc
3	https://youtu.be/W_r2b8U1J6k
4	https://youtu.be/cCbIjArKL4M

Tool Alignment Macros

The tool-alignment helper macros (Tool_Align_Start, Tool_Align_Test, Tool_Align_Done) are documented in the Dock Calibration guide. See that page for the latest instructions and demonstration video.