XOL¶

References¶

[4] m3 heat inserts
[3] Ø4x12mm ssRod (dowel pin) with a rounded end (if it has female threads on the back it will be listed as an M3, but make sure the pin is 4mm OD, that is what is important. We recommend the threaded pins for better fixing)
[1] 6x3mm magnet (N52 Highly recommended to counter the pull from the umbilicals. Note that most magnets not from a reputable source may say N52 but aren't actually. Recommend one of the two links below.)
[2] m3x6 or m3x8 FHCS (Flat head countersunk screw, MUST BE MAGNETIC. no stainless, as per TAP)
[1] OptoTap (only the sensor PCB is required)
[1] m3x8 BHCS (optional in v1.1)

[2] m3x6 BHCS (backplate lower mounting screws. m3x8 will be too long)
[2] m3x20 BHCS (backplate upper mounting screws)
[2] m3x8 BHCS (extruder mount to backplate)
[2] m3x6 FHCS magnetic (preload screws. m3x8 will be too long)
You will not be able to use stock 2.4 Z joints with XOL or A4T.
Replacement of your Z joints with something with a lower profile such as hartk123's GE5C Z Joint or Ellis'Short Z Joints is necessary to avoid bottoming out your Z carriage on the deck panel when using XOL or A4T.

No official PCB mounts from Draftshift Design. See User Mods below.

No user mod PCB mounts documented yet. Check the StealthChanger UserMods directory for community contributions.

Requires Shorter Z joints like Ge5C z-joints so you don't bottom out your carriage when homing.
Requires new smaller front idlers like the BFI or Mini BFI so it doesn't collide with the idlers.

Dock Width	Stubby Dock Compatible
76mm	❌ No

Calculation assumes 5mm spacing between docks. See Docks for details.

Dock Type	Description	Link
Standard Dock	Full-height dock with back and base	XOL Back and Base

XOL is not compatible with stubby docks due to toolhead geometry.

Dock Type	Size	Description	Link
Magdock Adapter	76mm	Magnetic dock adapter	Xol Magdock adapter
Magdock Feet	76mm	Magnetic dock feet	Xol Magdock feet