Yavoth Toolhead¶

Reference¶

[4] m3 heat inserts
[3] Ø4x12mm ssRod (dowel pin) with a rounded end (if it has female threads on the back it will be listed as an M3, but make sure the pin is 4mm OD, that is what is important. We recommend the threaded pins for better fixing)
[1] 6x3mm magnet (N52 Highly recommended to counter the pull from the umbilicals. Note that most magnets not from a reputable source may say N52 but aren't actually. Recommend one of the two links below.)
[2] m3x6 or m3x8 FHCS (Flat head countersunk screw, MUST BE MAGNETIC. no stainless, as per TAP)
[1] OptoTap (only the sensor PCB is required)
[1] m3x8 BHCS (optional in v1.1)

[1] m3x12 BHCS (optional to keep spacer in place)
[2] m3x35 SHCS
[2] m3 heat inserts
[2] m3x8 BHCS (optional in v1.1)
Several 5x2 or 5x3 N52 magnets to hold toolhead to dock (Highly recommended for non-magnetic docks)

No official PCB mounts from Draftshift Design. See Voron Toolhead PCB Mounts or User Mods below.

PCB	Extruder	Description	Link
EBB36	Sherpa Micro	EBB36 Mount With Cover	Sherpa Micro EBB36 Mount With Cover